Please use this identifier to cite or link to this item:
Full metadata record
DC FieldValueLanguage
dc.contributor.authorBarry, N.-
dc.contributor.authorHainsworth, Sarah V.-
dc.contributor.authorFitzpatrick, M.E.-
dc.identifier.citationMaterials Science and Engineering, A, 2009, 507 (1-2), pp. 50-57.en_GB
dc.descriptionThis paper was published as Materials Science and Engineering, A, 2009, 507 (1-2), pp. 50-57. It is available from Doi: 10.1016/j.msea.2008.11.044en_GB
dc.descriptionMetadata only entry-
dc.description.abstractShot peening is known to improve the fatigue performance of structural metallic materials. The improvement in fatigue life is derived primarily from compressive residual stresses that are introduced into the near-surface of the components and which hinder crack initiation and growth. Magnesium alloys are finding increasing use in automotive applications, but their relatively low strength means that they are highly susceptible to fatigue failures. This is particularly the case for cast alloys which may contain high levels of porosity. Shot peening may be of use, but the beneficial effect of the compressive stress may be offset by the surface damage associated with peening of a soft material. In this study the fatigue life of sand-cast A8 magnesium alloy has been investigated before and after a shot peening treatment to investigate whether shot peening is beneficial for a component with this combination of relatively low strength and relatively poor initial surface finish. Previous studies into the effect of shot peening on magnesium alloys have been limited to wrought alloys and there has been little work on the influence of shot peening on cast magnesium alloys. The residual stress before and after peening was determined by incremental hole drilling which shows that the peening process generated a compressive residual stress in the cast specimens. The fatigue results show that the fatigue life is significantly improved by the shot peening process, and there is also an improvement in the endurance limit. An increase in the surface roughness of the samples was found after peening but this was not found to be detrimental to the fatigue performance.en_GB
dc.titleEffect of shot peening on the fatigue behaviour of cast magnesium A8en_GB
Appears in Collections:Published Articles, Dept. of Engineering

Files in This Item:
There are no files associated with this item.

Items in LRA are protected by copyright, with all rights reserved, unless otherwise indicated.